Installation Tutorial For The Reversible Triangular Stand

Triangle Stand Installation Steps
Installing the triangle stand is not complicated; simply follow the steps below:

Preparation: Verify that all stand components are present, including the main body, screws, washers, etc.

Assembly: Extend the stand's legs, ensure the three legs are evenly spaced, and tighten the locking screws.

Height Adjustment: Adjust the length of the legs according to your needs to ensure the stand is level and stable.

Device Mounting: Place the device onto the platform at the top of the stand and secure it firmly using the provided screws.

 

Common Issues and Solutions
You may encounter the following issues during the installation process:

Stand Instability: Check if the ground surface is level; use washers or shims to make adjustments if necessary.

Loose Screws: Periodically check that all screws remain tight to prevent loosening caused by vibration.

Sliding Legs: Ensure that the leg locking mechanisms are fully engaged to prevent accidental retraction.

 

Usage Precautions
To extend the lifespan of the stand and ensure safety, please observe the following:

Regular Inspection: Before each use, check the stand's stability and verify that all screws are securely tightened.

Avoid Overloading: Do not exceed the stand's maximum load capacity to prevent deformation or structural failure.

Storage Environment: Clean the stand after use and store it in a dry, well-ventilated area to prevent rust and corrosion.